Originally Posted by
Bobinmt
I just got my new Li-Fe packs, there 220mah 6.6v. My charger will only allow me to select 200 or 250mah nothing in between and the instruction manual says NOT to exceed the battery's stated capacity. When I select 200mah it automatically wants to charge at a 2.0 amp rate. I can change this but my question is should I and if so to what?
Bill you say that your charging yours at .8 amp? or is that 8.0 amps?
Thanks again for any help provided..
Bob
Just charge at 200mah setting to be safe. You will have plenty of capacity for 8 mins. I only pull 70mah for 8 mins racing and 1 min warm-up.
I charge at .4 amps. Which is quicker than my 1s lipo will charge. It's easily charged before the motor to cools down, if you are running to multiple lipos.