R/C Tech Forums - View Single Post - Tamiya TRF416 / TRF416WE / TRF416X
View Single Post
Old 04-07-2010, 11:53 AM
  #8644  
MikeR
Tech Champion
iTrader: (15)
 
MikeR's Avatar
 
Join Date: Aug 2001
Location: Irvine, CA
Posts: 5,746
Trader Rating: 15 (100%+)
Default

Originally Posted by dameetz
I managed to test my car today with the Exotek conversion....All the set up was the same as i ran with the original chassis....Tyre used was Much More 32....The most noticeable handling improvement that I noticed was I have tons of grips...before this my car was a little bit twitchy on the rear and the steering was never the same between right and left input...usually the left input was more sensitive making it break loose (I have tried a lot of things BUT its still there...Note: My old 416WE had this problem too)....Today all the problems that I had was gone...i can make aggressive steering input and still did not break the rear loose....I m really satisfied with this Exotek chassis conversion....Yet I haven't fully balance weight the car (still batt side heavy).....
Hi Dameetz,

I have new 25% lighter weights coming in later this week. PM me if you want to switch to these

THX, M
MikeR is offline