Hey guys had a run with the V203 software tonite.
Ran the following:
Xray T3
Tekin RS
Tekin 17.5 with zero timing
FDR: 6.8
Boost: 50
Turbo: 10
End RPM: 7000
Start RPM: 2474
Ramp: 3.0
Delay: 0.4
Drag Brake: 10
Track: roughly 20meters x 60meters, medium traction
The car felt fast but not as fast as others running Black Diamond and tekins. Can someone please give me advice with regards to my setup? The car seems a bit slow coming out of corners and it seems to take a bit of time to reach top speed, it will reach top speed just before I enter a corner so basically by the time it reaches top speed I have to throttle off to go round the corner. It's flowing track so I don't use my brakes, instead I depend on my drag brake to slow me down. Or if I take the drag brake off I usually just roll through the corners. Any help would be appreciated guys.
Also when I first ran the car my initial setup was 5.63 FDR and 12 degree timing on the motor, but it temped at 105C, thought I blew the motor but when it cooled down everything was fine again, hope I didn't do any damage. So then I ran the above setup and final temp was around 75-80C.
Thanks in advance.