R/C Tech Forums - View Single Post - How many torque for securing engine head?
Thread: How many torque for securing engine head?
View Single Post
Old 04-05-2010 | 01:02 PM
  #2  
Turbo9000's Avatar
Turbo9000
Tech Fanatic
iTrader: (5)
 
Joined: Jul 2002
Posts: 783
From: Austin Texas
Default
Originally Posted by ttso
(I assume it's different for .12 engine and .21 engine?).
I wouldnt think so, the screws are all the same between the .12-.21, for novarossi anyways.

For the novarossi screws, i usually get them snug, not too tight, (tighten in a x-pattern to make sure ) the cheese head has a large bearing surface, alot of people will trade them out for SHCS but, you loose bearing surface with them. Hudy makes a screwdriver specifically for the nova screws. Its one of my favorite tools.
Turbo9000 is offline  
Reply