good evening to all, today I finally trying with calmly the new firmware, I decided to try the 230 with Speed Passion V3 10.5 T

I made several runs with different FDR, with different height of tire (sponge) and clearly different settings;

high tires and FDR 7.6 had a car that went pretty well a bit everywhere, with
temperature 80 degrees after 5 minutes, this was the only constant in the day, temperatures right on the limit in each run.

The last run (probably better) I did it with 58mm tires ratio 8.65 and temperature always 80 degrees;
These are the main settings:

# 4 = 9
# 9 = 2
# 12 = 8
# 13 = 3
# 14 = 1
# 15 = 4

repeat with motor speedpassion V3 10.5 T on Xray T2'009, the track has a straight length of about 55 meters, a mixture with two sharp curves and other curves almost stationary and restarts with a scican very fast. In short, a mix of everything.