Originally Posted by
biagio23
I have a problem with the tekin rs pro
used te esc tekin rs pro end tekin motor 10,5
The problem is this:
use the v203 tekin with software and with these values:
4 trottle profile
Timing boast 35
turbo boast 10
Dealy 0.2 turbo
3.0 turbo ramp
Start RMP 4678
end rpm 12500th
Final Report 6.5
The problem is that the regulator is very strong, but after 3 minutes significantly diminish the performance as if any further attacks on the turbo, I tried various things but I do not know what the problem is, my friend uses tekin like me and with the same settings and has no problems, and how I use ezpower lipo 50c
No welds are fine
No welds are fine
No welds are fine
Change the following.
Set the motor timing on 5
Timing Boost on 50
Turbo on 5
Turbo delay 0,4
Turbo ramp 2
Keep those RPM settings and gear a bit lighter.
I think that the timing is to high and to much ad once with the low Turbo delay.
What is the motor temp?