For those not noticing performance difference between the beta and old stock firmware. What I did, was downgrade to an older version, then re upgrade to new version but don't calibrate it.

Tried it again today, settled on a 6.82 FDR for 17.5T with the older version of the Team Orion Vortex motor. After a 5min race the motor was around 75 degrees, on a Sunny Aussie day. Used a heat sink with no fan. Settings were as follow:
"DRRS" Start Mode: Level IX
"AMTS" Timing: 11.25degrees
Neutral Range: 6%
12:5
13:1
14:1
15:3

With this new software, the top end was I think the same as the tekins but was lacking in punch. Will run this again on Tuesday night and may try other settings and with a DUO1.

ixlr8nz:
Yes the throttle position problem did happen to me, but only once and I don't think I hit something really hard as well. What I did was turn it on then off and then switch ti back on again. When I did this, I hit stuff so hard my battery moved a little in the tape and the throttle position never changed again. But I also have my throttle epa set to 130%.