R/C Tech Forums - View Single Post - Con Rod for a Mega zx21
View Single Post
Old 03-12-2010 | 05:48 AM
  #13  
M7H's Avatar
M7H
Tech Elite
 
Joined: Dec 2004
Posts: 2,198
From: The Netherlands
Default

Originally Posted by sdphilips
So, were these engines prone to rod failure?
Just read your question....

No they are not.
The 4.4mm small end version was, but the current version isn't.

I race them hard, and reached 10 liters (2 gallons) on 1 rod, to test it's durability.
Even after this there was no visible wear compared to a new one!...
Don't forget that a rod gets a lot of stretching during his life, so no visible wear does not mean it is not tired and can snap.....
M7H is offline