R/C Tech Forums - View Single Post - Go-Tech Engines Thread
View Single Post
Old 03-09-2010 | 02:17 AM
  #10205  
Poinas2
Tech Regular
 
Joined: Nov 2007
Posts: 377
Default

Originally Posted by vmlopes
As you all know I am still running in a GO GX5R can get its started fine with a little heating up etc. have run about 3 tanks through it so far.........

Have checked my throttle linkage etc. and the carb slide and idle position with a 1mm drill blank and it returns to the same position from WOT to closed everytime........now when I get the car running and I'm still only doing little quater throttle blips.........its almost like when it throttles up it stays there until I pull the brakes on? At tickover its also starts to rev up slightly on its own to the point that the clutch is almost engaging??

Any ideas
If you are 100% sure the slide returns immediately so check for airleaks and fuel/pressurelines etc.
Poinas2 is offline