R/C Tech Forums - View Single Post - 1S setups with 2s receiver packs… Bad!
Thread: 1S setups with 2s receiver packs… Bad!
View Single Post
Old 03-02-2010 | 08:47 PM
  #17  
YmeBP's Avatar
YmeBP
Tech Elite
iTrader: (32)
 
Joined: Aug 2007
Posts: 2,927
Default
Quote:
Originally Posted by TeamTekin
Normally we would remove the red wire from the esc receiver plug and we would not care what voltage the receiver pack is, but in this case we are leaving the red wire in place so we can use the receiver pack voltage.

Originally Posted by bjgarner43
I'm not clear on this sentence.

I am planning on trying a 1S Lipo system on Wednesday. My intent was to tape the ESC Power Switch in the OFF position and plug a 6 volt 5 cell receiver pack right into the receiver BATT plug.

Will this work OK, or should I be doing something more?

Thanks!
If you take the red wire out of the speedo receiver wire you are preventing any electricity from the receiver pack from reaching it.
YmeBP is offline  
Reply