Originally Posted by The Fox

I have to ask because this is getting kind of old.

I have a speedpassion GT2.0 LPF that is having massive problems with calibrating throttle. I have a M8 and synthisized airtornics module and recievers. When I hold the set button down and turn the power on like you are supposed to do, it beeps 12 times then goes into calibration mode like it should. But it will just go into an endless loop of 1, 2, 3 beeps as I do the button presses and trigger movements.

If I let up on the button before it finishes the 12 beeps, it will be silent until I press the button then it will jump to 2 beeps for full throttle. Once I press it at full throttle it does the 3 beeps, I set full brake and the car just takes off at full throttle.

I have it set the best i could now, but that is I need full forward throttle trim and subtrim on it to not go into brake.

I have played with change everything; firmware, neutral range, trim, and sub trim. Any ideas on this problem?

Nick