Originally Posted by
skyshen
what u mean by wrack the car? ... i put the tamiya spec motor but with RSpro esc ... cuz it can run brushed motor on that esc ~ but I'm really want to ask is the hotwire work on my mimi spec motors? or only the brushless?
Yes that works.
I thought you wanted to use a 13,5T.
Originally Posted by
hardmankam
Hi mikky32,
Thanks for your setup info.
May I ask what FDR/Rollout are you using for your setup? What is the size of the track and straight away? Many thanks!
Sorry it was 7,8 what i was running.
The motor became 89C so watch out and check your temp.
Play with the Turbo ramp to have a different acceleration feel.
Originally Posted by
2wdrive
probably there is some issue with a loose wire or something as i could reproduce it once in a while while fidling with the wires. It also did it when i was fidling with the red and black power wires but that might also have been the sensor cable that moved in the esc while i was fidling with the power wires.
edit:
I raced 3 or 4 whole days with the new software and there was nothing wrong so i don't think it could eb the servo. It only happend after the crash.
Check your wire into your receiver.
It can look good but I changed it and my problems were solved.
If that's not the problem. set it back to the V200. Check it than and as that works good, set it back to V203.