Originally Posted by
storytyme
That chart is what I was looking for, but when I looked at the 48pitch chart it says that you can have a 75 spur with a pinion from 24-41. When I put in a 29T pinion the gear couldn't get close enough to the spur to mesh. Am I missing something? Thanks again.
I've never tried this combo so not sure if it'll fit.
Is there any space left in the motor mount slots? If there is check the M3 bolt that holds the stock motor mount to the rear bulkhead. When I put my car together the first time this bolt head was sticking out quite a bit and my motor wouldnt slide up close to the spur. I had to countersink the motor mount countersink some more to get the bolt head to sit flush with the motor mount. My motor could then slide quite a bit closer to the spur.