R/C Tech Forums - View Single Post - Go-Tech Engines Thread
View Single Post
Old 02-05-2010 | 04:39 AM
  #9916  
Flanno's Avatar
Flanno
Tech Master
iTrader: (2)
 
Joined: Jun 2009
Posts: 1,566
From: Sydney
Default

Originally Posted by Gizmatron
Well need a new crank for the MG66.. tried the 808 yesterdayand noticed a lot of end play in the clutch bell so yanked the motor to re-shim it and I found the end of the crank has worn down some. Not surprising considering how many sets of clutch bearings I destroyed last year.Bummer none the less. Oh well not an expensive fix and I will be starting the season with an almost new engine again.Not to mention a lighter car.Hoping the new Ascendancy racing 4 shoe clutch should balance out the wear on both bells and bearings too this year.


I'v heard good reports from guys here using that clutch, good luck with it Giz.
Flanno is offline