Has anyone with the XeRun 80A or 150A ESCs changed the Punch or Timing settings to Zero or near zero?
The previous EZRuns had problems where if either of these parameters were set to zero or close to it, the ESC would burn up. I'd like to know if they resolved that in the XeRuns.
It seems 1Blade1 had his timing set to 0 with no problems, but I'd like to get a few more reported cases that it's ok to do.
Right now, I'm running my EZRun 150A with a Neu-Castle and have the timing at 9.75* (from default 15*). It cogs at low speed, so I'd like to set it lower, but am scared to knowing that quite a few EZRuns had this problem.
Thanks.