Hi friends. Greetings from Malta.
Took my SD apart yesterday to do the bearings, diffs etc. First time in about 6 months.
PAUL - LONESTAR.
I use either MR4TC rear alloy dogbones all round on the SD, or Tobee alloy dogbones. They all wear quite a bit, especially up front with hot mod motors, and a spool. The only problems I have had with the Tobee ones are if the car lifts off a banking and lands heavily on power. Then they snap immediately. But then so do the Yoke alloy ones under those sort of conditions.
I have used Titanium ones in the past but the wear rate on them is even worse.
Thanks everyone for info about diff lubrication.
Does anybody know where I can get an alloy spool - like the one IRS make for the TC3? I made my own which is OK but I want the real thing to sell.
STEVE.
Can you PM me the dealer price for 3 CGM kits. I'm preparing an order for Yoke parts. You may be able to help with this too.
Thanks and regards
Joe from sunny Malta.