R/C Tech Forums - View Single Post - Yokomo MR-4TC SD
Thread
:
Yokomo MR-4TC SD
View Single Post
01-27-2004, 05:26 PM
#
6276
forty6
Tech Master
Join Date: Dec 2002
Posts: 1,922
Trader Rating
: 0
Re: front bones...
Quote:
Originally posted by Lonestar
All right, let's start it all over again... What's the best bones to run with a one-way (metal outdrives):
- Square Ti Bones: Expensive, wear out fast. big flat spot after, say, 50 packs...
- Tobee Aluminum bones: good stuff, if you're masami and never hit boards... else... SNAP !
-Stock steel bones: I put them on yesterday... 8 packs... big flat spot today. Less expensive than Ti, though.
So what the heck should we run? Cobra, are you looking into using R2's bones into the SD?
Paul
I will let you know tomorrow for sure if the MIP cvds fit. I am building another SD at the moment and I have both the alu and shiny fronts for the old Mr4tc. (thx again rc-z). I will post pix later.
Reply
forty6
View Public Profile
Find More Posts by forty6
View iTrader Profile