Problem with my RSpro after applied setting...
I swoop the ESC between two different cars (onroad to offroad and offroad to onroad)... I only have the one esc. Last week I used it for the offroad truck and it worked fine, no problems! This week I'm running onroad (12th)
I got it all installed, reprogrammed the 12th scale setting, wired it to the motor (Tekin 13.5 sensored) all correctly ABC and sensor wire plugged in but no power gets to the motor.... The ESC lights turn on and goes though its normal wakeup flashes but no sounds, I thought that was strange. When I pull the trigger the led lights increase and flash at maximum throttle which is normal, but still no motor. I receive power to the servo and it steers but I don't understand why I'm not getting any current to the motor, it worked great last week.
Could it be a bad sensor wire? Will a sensored motor still run with a damaged or intermittent connection? I noticed some of the plastic coating has worn in a couple of places...
Anyone have any advice??