Originally Posted by
Alex C
Carl,
Sorry for the late reply.............. I would recommend to start with the attached profile below, specificly Profile No.1.
As to your Trinity Duo.........I would start with +15* setting, further I would recommend to rollout around 3.05 to 3.10.
One word of caution this profile is very aggressive and may provide to much torque on exit, if so move the entire curve down 5%.
I would also recommend to temp your motor at the four minute mark just incase.
Try it out tell me what you think, I'm sure we can make your 1/12 Scale just as fast as the others mentioned!!!
Best Regards!!!!
Alex
Thanks Alex....not sure what yo mean by Profile #1? Do you mean the default setting on the v1.5? I did not see an attachement?