R/C Tech Forums - View Single Post - RB Concept Engine Thread
Thread: RB Concept Engine Thread
View Single Post
Old 01-25-2010 | 05:36 AM
  #449  
Grinder's Avatar
Grinder
Tech Master
iTrader: (2)
 
Joined: Feb 2003
Posts: 1,864
Default
Originally Posted by Mike 78
Hi,

i have just purchased an RB T9, i was just wodering what different methods people are using to run there engines in. i have heard that Murnan advise to remove the clucth assebly etc and also what percentage nitro do people use to run in as well.

Thanks Michael
Only remove the clutch if your breaking in the engine with a propeller. In the car use a very early engaging clutch. I like a load on the engine from idle up during break in.

http://murnanmodified.com/breakin.php
Grinder is offline  
Reply