Originally Posted by
mikky32
I'm running a LRP X11 10,5T and I'm now geared 7,4 but I gear next time a bit lighter and change some RPM settings and set my Boost a bit higher with some more Turbo.
This is what I have now.
Boost 45-50
Turbo 5
Turbo delay 0,3
Turbo ramp 3
Gearing 7,4FDR
Start RPM 2700
End RPM 9000
Next setup what I will try.
Boost 50-55
Turbo 10
Turbo delay 0,3-0,4
Turbo ramp 2-3
Gearing 7,8-8FDR
Start RPM 2000
End RPM 10000
The first setups works good. Good acceleration and still good to drive.
Better acceleration and a higher top speed but you can still go around the corner. Turbo comes in very smooth.
The second I hope to get some more power in the infield.
Top speed will be lowered to the same as above. I must try some setups with the Turbo.
Im running 13.5 LRP X-12 Motor (4 dot timing)
drag brake off
brake strength 100
limiter off
neutral width 5
voltage cutoff 2
motor type 1
throttle profile 5
timing boost 48
turbo boost 8
start RPM 4700?
End RPM 10000
Turbo ramp rate .2
final gearing 7.98
I have to much rip coming out of turns. Any idea how I can calm my motor down??? besides using my finger to control throttle. Any help would be much appreciated.