Originally Posted by
rnd_tang
OK,
I can not work it out. I swapped the servo with another one that I know it working perfectly and nothing, same issue.
Tightened the rear diff up abit, nothing. Chassis is completely flat…
Could it be that I have a faulty front spool? I will try more toe out tonight...
Well, it's hard to say from a distance.
Make sure your shocks have the same length and your shocks filled equally (R-L equal rebound).
Set your droop and downstop properly, and make sure your suspension blocks are aligned perfectly (equal toe value left and right side).
Look for some parts that might be binding, or maybe a shaft pin has loosened a little. Look for faulty bearings as well.
Make sure your camber left and right are set equally and give the front a little bit toe out.
Try to mount a new set of tires.
You say you tightened your diff a bit more, but does your diff slip or doesn't it?
If your delrin spool cups are worn out, replace them with new ones.
Servo saver screw too long?
Transmitter ok? Does the steering-wheel/stick move smooth around the neutral steering point, or does it get stuck a bit around the neutral point (if you know what I mean)?
That would be my checklist for now...