View Single Post
Old 01-06-2010, 12:10 PM
Tech Prophet
iTrader: (96)
houston's Avatar
Join Date: Sep 2004
Location: Sherwood,OR
Posts: 15,747
Trader Rating: 96 (100%+)

Originally Posted by 8secnotch View Post
Just in case you don't know
TDC = top dead center
BDC = bottom dead center

The flywheel has nothing to do with this so leave that alone. Just make sure the piston is at TDC before you go and pull the back plate off your engine and you'll be fine. If I was you I think I would get someone who knows what the internals of the engine are help you out before there is more problems then just a broken piston skirt.

Also don't all engines have a o ring to seal the back plate anyway? I know the ones I've had do. So why mess with it.
Right on the money 8sec !!!

You shouldn't have to seal anything on a nitro engine if its a quality engine !!!
houston is offline  
Reply With Quote