Originally posted by ROBORAT
who here has tried using the losi rear hubs in the tc3? what exactly is being achieved by doing so? i know cyrul used to do this so he could set toe in at the hubs rather than using the arm mounts/holders to get toe. but he also had to eliminate the toe angles at the arms pivots by using an inner F block in the rear. if i still use the arm mounts to achieve toe angle and simply switch to 0-degree losi rear hubs, what changes in handling can i expect? and what ball stud should i use on the hubs, a silver or black stud? thanks in advance. 
The rear Losi hubs give the car a little bit more rear traction(using the 0 degree hubs) because it changes the angle that the link is connected to the chassis, and alters the length of the link. When you run the inner hole on the hub, that is close to the outter hole on the Associated hubs. I stoped using the Losi hubs because one of the striped out and i had some extra Associated hubs lying around
. When using the Losi hubs, I used the black ballstud because the hole is fitted in the rim.