R/C Tech Forums - View Single Post - Fail safe
Thread: Fail safe
View Single Post
Old 01-02-2010 | 12:55 PM
  #6  
LOW ET's Avatar
LOW ET
Tech Elite
iTrader: (109)
 
Joined: Dec 2007
Posts: 3,305
From: cleveland, ohio
Default
Originally Posted by Duster_360
Looking at the manual that came with my 3PK, it says "Failsafe - settings stored by the rcvr, used only if the rvcr fails to receive clean, intelligible signal from the transmitter".

Any disruption of the signal will activate the failsafe. If someone switches on a tx on your channel, the failsafe would activate.
with that being said my next question would be, are we talking about a stand alone fail safe or one that's built into a receiver?
LOW ET is offline  
Reply