R/C Tech Forums - View Single Post - The Speed Passion Thread

12-28-2009 | 11:11 PM

#1510

mild seven

Tech Master

iTrader: (63)

Joined: Mar 2005

Posts: 1,070

From: Australia

Quote:

Originally Posted by FIVE 7

I recently installed the 110 program in my LPF in my 12th Scale, 1S LiPo car. I am running the Novak booster and it ran fine before on the 312 program. I did a little re-wiring on the car and then installed the new 110. Now everytime I go to fire it up, I get the "beep beep" signal which according to the instruction sheet is a "high voltage/low voltage" issue. I'm not sure if this is the program change that I did or something in the way I wired it. I triple checked the wiring and it all looks good.

Just curiuos if anybody else has run into this?? Any help, suggestions?

you will probably have to turn off the lipo cut off, the settings may of changed when you uploaded the new software. my friend had to turn off the cutoff with his GT speedy to work.

Reply