R/C Tech Forums - View Single Post - front engine bearing
View Single Post
Old 12-27-2009, 09:56 PM
  #15  
smokinu
Tech Champion
iTrader: (82)
 
smokinu's Avatar
 
Join Date: Apr 2008
Location: Hughson CA
Posts: 5,595
Trader Rating: 82 (99%+)
Default

Originally Posted by Jaz240
If your mid range is still factory settings and you leaned out the top, you have a bad tune. The needles need to be tuned together, to get the proper tune. You are surely fat on the bottom. your temps are also too cold.
that is very true james,

we dont really know where he is getting his temps though because he takes them all over the engine.

the only temp you need is right on the glowplug witch should be right around 190-230

if its around 50 degrees it will be cooler on the engine as it has cooler air running over it.

if its 100 degrees the engine is going to read in the 220-240 range

the ninja motor can run all day long at those temps...

dont tune to temp btw if its making some good smoke all around and running fine and making all the jumps on the track with out much effort then leave it alone.
smokinu is offline