R/C Tech Forums - View Single Post - Store Mode Hyperion EOS0606i

12-26-2009 | 09:27 AM

#2

slow_jun

Tech Elite

iTrader: (14)

Joined: Aug 2009

Posts: 2,739

From: sa Earth

Quote:

Originally Posted by mccoop

I just bought a Hyperion EOS0606i and thought I would try the "Store Mode" and when I hooked the battery to the charger and selected the correct capacity and number of cells then pushed the start button I got "CHECK BATT OPEN CIRCUIT".

I do not have the battery hooked up to the balancer. Will this mode work without that hooked up?

Secondly, if you do need the balancer hooked up, how do you use "Store mode" on a single cell pack?

Any help would be great.

Thanks,

Mike

Hi Mike,

got the same charger as yours, think you need to plug in the balancer plug before you do anything on your batT ( if its more than one cell), else you will be getting the error indicated. As for single cell i havent tried it but i think you will still need to indicate the correct number of cell and also the balance plug as you will see that the (+ Positive and - Negative) wires has a small wires (balance wires) that is connected to the balance connector thus the charger will detect the cell/s connected to the charger port.

Reply