Ed,I found out the problem to my motor I was having.The slipper clutch plate was not pushed all the way in (my fault
),so the spur gear was just spinning on the gear shaft coming out of the tranny case.The car would just start to roll at full throttle but would gain momentum after a few seconds.The gear was spinning frealy.I plugged in the software to my labtop but it says that I dont have enough power to support my USB cord.I guess I will have to try a regular table top pc.I do have the programming card with 3 files on it,but it would be nice to set my own stuff.Thank you for all the help Ed and Brad.That link you gave me discribed sensorless and sensored motors to a T.A lot of help.