Originally Posted by
da_John_wee
agreed, I think I did fix most of those problems on my car already except that LCD/RCD axle problem, for the axles I googled few time and found a ways to heat treated the metal at home, I might do few sets once my local track open it's door.
for #3 you can just use a Jr link and the camber rod became same length as the Lower arm, do you need longer than that?
I allways use Jr link (I try std. link but don't like). The question, (for me and my drive style) is that the hole #3 give too many high roll center; #4 give too many low roll center, so with #3 position but 2 mm more longher link..........
you should be obtain the halfway
ciao ciao