I really don't wanna go back through this whole thread to find out which is the best pipe for the .24, so I'm gonna ask it again, although I know it's been answered..

a local guy has convinced me to get the Trinity .24 for my D8T. He is running one in a MBX6T and getting around 12 minutes run time with JP6 pipe and making goobs of bottom end, and decent top end.. Out track is really tight, and only one short place to air one out.. He has the pre-run, I am looking at the full-mod version for that little extra punch and slightly better run time.. I'm heavier on the throttle than him usually..

Anything better than a JP6 for run time, I know power is relative to the guy driving? BTW his temps are under 200 everytime he runs it.. I know cause we pit for each other if we aren't in the same heat or main..