Thanks Georgec,
Punch Control = 50%. If 100% is for better traction and 0% is for no traction, 50% seems like a middle ground for racing and bashing.
Dead Band = widest setting? Is “Dead Band” an actual option or is it called something else?
Timing = “0” instead of normal or one step lower? What does “Timing” truly control?
Auto lipo cut off = Auto Detect with voltage setting to 3.2. Is this the same as “On” and is 3.2 the right setting for a single MaxAmps Hard Case 6500mah 60C 4S 14.8V Lipo Pack?
Drag brake = disabled
Brake Power = 25%. Is this the force or speed of braking? I don’t want it to over-brake causing higher temperatures to the BM.
Georgec, you recommend replacing the 4 suspension dog bone shafts with D8 shafts? Are these the same as the WCE shafts? Can you tell me the part numbers / lengths for each?
Front Left Suspension Axle = ?
Front Right Suspension Axle = ?
Rear Left Suspension Axle = ?
Rear Right Suspension Axle = ?
THANKS A TON GUYS!!!!! CHRISTMAS IS GOING TO ROCK THIS YEAR![/QUOTE]
Here are links to the drive axles you will need Cheap, stock up you will need these!
http://cgi.ebay.com/NEW-Hot-Bodies-D...item27addf0f4f
http://cgi.ebay.com/NEW-Hot-Bodies-D...item27addf0fb8
As for dead band yes that is what it is called it controls the amount your finger has to move to transition from throttle to brake, to start make it large.
Timing controls the amount of rpm's the motor will turn. Trust me set it to "0"
Auto LiPo will do just that it automatically counts the number of cells being used then in the Castle Link software it allows you to set the voltage cut off per cell. 3.2 is a safe setting!
25% is the lowest brake setting. All you should need.