Originally Posted by
Dane
So if the receiver, like the airtronics, can only handle 6V and the operating voltage of the ESC is 6V, no receiver pack required, correct?
For 1S you will still need a receiver pack or a booster to make sure the receiver and servo get 6V during your run.
Originally Posted by
Dane
If the receiver can handle up to 7.4V but the ESC has again, an operating voltage of 6V, I need a receiver pack?
For 1S you will need a receiver pack or booster regardless of how much voltage your receiver can handle.
Originally Posted by
Dane
This is all assuming 1S Lipo. When using 2C lipo, the pack provides enough juice for the receiver, servo, and motor, no matter what the specs in voltage are for esc and receiver, correct?
Correct.