View Single Post
Old 12-13-2009, 11:34 AM   #11107
Tech Master
Xpress's Avatar
Join Date: Nov 2001
Location: Dirt sucks!
Posts: 1,621
Trader Rating: 3 (100%+)

Originally Posted by YFB View Post
tried to mount the 0.30 sway bar but the grub screw doesn't go far enough into the ball to clamp the sway bar. ie. the sway bar isn't thick enough. works fine with 0.40 sway bar. is it just me or is this a manufacturing defect? any work around?

If you don't have the proper tap to clean the hole up you can also take the set screw on the end of an .050 wrench and spin it against the top of a cut off wheel etc in a dremel to taper the end of the screw. This will allow you to clamp down on the .030 wire.
"Desire is the key to motivation, but it's the determination and commitment to an unrelenting pursuit of laying it down - a commitment to excellence - that will enable you to attain the success you seek to beat ass."

Xpress is offline   Reply With Quote