View Single Post
Old 12-13-2009, 09:58 AM
Tech Master
iTrader: (2)
avs's Avatar
Join Date: Jul 2006
Posts: 1,175
Trader Rating: 2 (100%+)

Originally Posted by YFB View Post
tried to mount the 0.30 sway bar but the grub screw doesn't go far enough into the ball to clamp the sway bar. ie. the sway bar isn't thick enough. works fine with 0.40 sway bar. is it just me or is this a manufacturing defect? any work around?
in order to grip the .030 wire, i had to use a tap (a bottoming style) to clean up the bottom of the hole. i didn't have the correct tap, so i took the oldest one and ground the tip. this won't start a hole well, just start the thread carefully so you don't crossthread it.
avs is offline  
Reply With Quote