Hello everyone, thank you in advance for your assistance.

I bought a Kyosho Ultima GP Type R, I know is an old model, I got it with a Dynamite .12 engine, the Chasis has a plastic piece that goes over the engine between the head and the carb.

The problem is that the carb needle hits the plastic piece and at the "closed" position if I look inside the carb it has a 2mm (maybe more) gap, I haven't start the engine untill I am sure, but I suspect this will give me some troubles.

If I disassemble the carb, do you know if I can position the carb needle further from that bar? when fully open it points straight with the air intake.

Thank you all.

Whish I could post photos, but I am new and system wont let me so, please use the following address, just remove spaces .

h t t p : / / img197.imageshack.us / img197 / 6553 / kyosho12dynamiteproblem.jpg