R/C Tech Forums - View Single Post - Serpent 710
Thread: Serpent 710
View Single Post
Old 01-12-2004, 10:10 PM
  #2917  
InitialD
Tech Prophet
 
InitialD's Avatar
 
Join Date: Feb 2002
Location: MORDOR
Posts: 19,679
Default

Originally posted by kreidel
Did he run it with the DRS active?
Nope. It was set to neutral. Ok from what I can remember off my head, basically he used 35 wt Serpent shock oils with 4 hole open all around. Started with all yellow springs. Later on the A main, he changed to all red and he felt that it was a bad decission as all yellow felt better for him.

No front sway bar. Back sway bar is set 3 mm from the tip. Front roll center set to have 4 mm spacer shims below the arm (lowest roll center). In the rear, shorter upper arm with the lower inserts set to the top (UBO / LT) to give higher rear roll center. Rear diff set to very tight. Caster is 3 mm spacer in the front of the upper arm. Downstops 0 in front and 6 in the rear. Tires were 62 mm 40 shore all around. That's about all I can remember.
InitialD is offline