Originally Posted by Marley813

Recently found out about these sweet motor mounts from Brandon at EliteRC. While checking out his site, I seen his mbx6t. I wanted to something similar, so after a few PMs with him I got started.

Here's my original layout, I started with a FT RC8t & a AE e-conversion. I didn't take a pic before tearing it down, so a pic of me SC8e will have to do, basically the same thing.



First thing I did was flip the diff around to check for clearence.



I tryed flipping the riser around too, but that ain't gonna work. So the diff riser & chassis needed clearencing. Unlike Brandon & some of you, I got no mill so I just used the trusty 'ol dremel & grinder.

First the riser.



Then the chassis.



That's done & the spur has all the clearence it needs.



Now, on to getting the motor mount in...............