Originally posted by marzin
HI Fellow Yokomos!,
I remembered many post ago, there was some step by step instructions on how to flip the servo 90 degs, any kind souls still hv the link to that ?
I would like to try that too. would you need to drill holes for the servo posts?
Thanks a Million!! 
check out the pic 3 posts above
use the included but not used servo saver piece on the part tree to build the servo saver, then swap the left and right steering columns (left to right and right to left), then rotate the servo. if you use servo tape then you don't need to drill holes, otherwise line up the servo, mark the holes, drill and countersink the 2 new holes on the bottom of the chassis