Originally Posted by
gortan
i've tried this setup and the improvement was significant. i went from 20 to 10 boost... and geared up two teeth on the pinion from 27 to 29 (30 does not fit).. Temperature was still around 60C.... so I could push it harder... the turbo entering was noticeable.. so i guess i could make it a bit earlier... from 0.7 put it back to 0.5... i'd still like more breaks if possible
that's until the new tekin pod arrives
thanks for your tips mikky.
g
The Speedpassion motor has weak brakes. With an other motor this will improve.
I found that with a lower Boost, the motor has a bit more braking power.
Can you change your spur gear?
Use a smaller one, than you can gear heavier.
With a motor temp of 70C to 75C you will see that the motor will go even better.
Don't let the motor get to hot. It can not handle that.