Originally Posted by
LOW ET
this is intended for
RANDY PIKE but anyone can chime in.
can you give me a setup to put on my tekin rs esc for carpet 13.5t rubber touring car (v200 software). i'm using thunder power 5000 40c lipo, lrp x12 13.5t motor, same car and setup larry fairtrace ran at the classic.
track is 90'X40'
Nice layout. Almost the same size are were I drive on my races.
I use a 10,5 lipo and i'm geared 7,3FDR.
I have seen a driver with the X12 10,5T but even with a lighter gearing than me his motor went way to hot so I would say gear very light and check your motor temp allot.
Can you set the motor on 0?
If so set it on 0 and the boost 20
Turbo max
Turbo delay 0,3 to 0,4
Gearing i don't now but I now it's just like the Tekin redline motor. very light.
If you keep your motor standard timed set your boost between the 5 and 8.