Originally Posted by
racer6888
Does anyone know what the top end needle should be set to in terms of turns out. I dont like the idea of set it to "flush." That is vague in my opinion and one's flush may not be actually flush. Since you only turn it in maybe a half turn at most, I'm curious if my start point is off.
What's vauge about "flush" ?? Even if you are off by a 1/4 turn from the absolute flush setting, you will be within half a turn of a performance tune on the HSN (providing you have a long needle LSN carb. Not all countries get the same LSN needles in the carbs depending on what the distributor asks for, so check this first).
No point screwing the HSN in all the way and risk damaging the needle end if you have to screw it all the way out again to get to the correct setting anyway.
