Thread: Serpent 710
View Single Post
Old 01-05-2004, 10:18 PM
  #2668  
InitialD
Tech Prophet
 
InitialD's Avatar
 
Join Date: Feb 2002
Location: MORDOR
Posts: 19,679
Default

Originally posted by jfc_tech
I don't understand the term "small end float like 0.3 or 0.4 mm"?? I set mine like no mevement at all horizontally but if i spin, it moves freely....is that not ok?
I was referring to the procedure in Step 8.6. The manual recommends 0.7 mm.

After you install the clutch with all the bearings in place, you should have very minimal or no play at all. Like you say, when you spin the clutchbell, it will spin freely without touching the clutchshoes.

Sometimes it is necessary to add shims between the clutchnut and the bearing as per Step 8.7 to take out most of the end play.
InitialD is offline  
Reply With Quote