R/C Tech Forums - View Single Post - CRC Battle Axe, GenXPro 10, 1/10th pan, Brushless, Lipo,4c, Road, Oval,TipsandTricks
Old 11-14-2009, 05:28 PM
  #1309  
slotracer577
Tech Adept
 
Join Date: Jan 2009
Location: colorado
Posts: 237
Default

Had a little more test time on the offset rear pod. This tightned up the car a bit and seemed to add rear traction. Was able to run gray rears on carpet instead of white or pearl white. Car still had a slight push, should have gone even harder in the rear but ran out of testing time. Turned equal laps to the centered car with softer tires. So should be faster if I can get a setup that turns well.

so the pod did what I wanted, added LR weight in the 1 cell and tightned up the car a little. Now I need to work on a setup that takes advantage of this. Was able to go to the long LF arm along with the higher roll center blocks. this seemed to really help the front end work well. RF is no longer wearing a lot faster than the LF. Rear still needs to be freed up a little, but should be able to get there with springs/tires.
slotracer577 is offline