Originally Posted by
f2000racer
Thanks for the info Still Bill and PHI/BMI racer.
What Phi rear belt should I use and where can I get one? I tried an x-ray 180mm belt but it's very very tight after installation (used x-ray since I thought it's the same as it's also 180mm size
)
Depending on the tension of the front belt I have used the corally short rear belt, if I ran out I used tamiya 415 black rear belt, Robitronics Avid rear belt works too. I recommend the Corally belt, but sometimes I have snapped 3 or 4 and don't have anymore...
Some of our tracks here are not that great and it only takes one small stone and snap...
Check in the PHI manual as to which belt you need. It will depend on your set-up.
www.stormerhobbies.com has Corally parts (belts), but if you in the USA then the local Corally USA store should have. Best thing would be to phone them.
Caio
