Originally Posted by
boba.slave
Hello
Can someone help me with the following problem?
I'm driving a T2'009 EU-version with a one-way axle (instead of a spool). The pin (10mm) in the T2 drive axle (front) is getting loose while driving. I've followed the instructions meaning that I did the greasing of the T2 drive shaft coupling and the drive shaft 52 mm, and thread locking the hex screw SB M3x2.5.
Although the hex screw is still tight, the pin gets out of the T2 drive axle at one end, hitting the composite steering block. And because of this the T2 drive axle doesn't work like it should (because the pin is sticking out the drive axle on one side).
I hope you understand what I'm trying to tell...
I had this same problem with my 09 nd the solution was to contact rcamerica and get the proper length pin.