Originally Posted by plummers

ok thanks martin for your soldering advice, i will probably send it in and get the new firmware and wires done at the same time.any idea of how much and how long it takes?? plummers

Originally Posted by spud37

martin i wonder if you can help

Customer has a brand new 120 with version 7.2 software.
running standard mode 8 from factory, set using tx as customer has no pc
this has melted 3 motors, gm, novak and nosram
the motors are running at approx 100deg c after only 2 mins!
i cannot see what could be causing this ?
i will download settings and send gda when i have gda, but what could cause this?
i run same speedo same geraing and motor at club and mine run fine and only 60c.

Many Thanks

Richard Baker