Originally posted by Steevo
Hello All,
I was just wanting to know from those guys with the Tech 3 piece Shaft, Do you have the shaft adjusted so that the shaft has no float in it or do you adjust it so that the shaft is tight between the ends. Also where did you put the second "O" Ring?? Not the one that goes around the alloy spur gear holder but the other one.
Any help is appreciated
steevo
what i've done is place the small "O" ring inside the front drive cup. and as for adjusting the float. i left about 1-2mm so the shaft can have some space to move around if impact does occur.