On a belt drive car, the brushless motor rotation is counterclockwise.

On a TBO3 IFS the brushless motor rotation should move clockwise to move forward.

I install the esc and motor to my TB03. and as expected the car runs backward. So i need to reverse the rotation of the motor so when i hit the throttle it will fun forward.

So to reverse it, I use the reverse function of the Thottle: from NOR to REV.

PROBLEM: if I change the throttle setting from NOR to REV, the motor will start running backwards even in the Neutral position. if i press the brake the motor will run much faster still in the backward direction. If I press the forward trigger the motor will stop. Next I recalibrate the ESC in the REV setting and still the problem is the same. I also set the m11x setting to default and made a new model.

I tried a FUTABA 3pm transmitter. In NORMAL mode the car also runs backward. then I tried the throttle reverse function of the 3PM and the car runs forward, normally. I did not recalibrate the ESC when using the 3PM.

I used it on this ESC and motors.

SP LPF with SP 13.5T motor

LRP SPX with vortex 4.0T motor.

Can anyone with the m11x try the Throttle reverse mode and see if you will encounter the same problem also? and can come up with a possible solution. thanks in advance