Originally posted by rcjayy
D
if i loosen the grub screw on the brake, i can move the whole shaft that the 2sp gear is on, is this what you mean when you say move the 2sp to the left?
You can move two pulleys. One is the 22T layshaft side pulley and the other is the 24T brake pulley in the middle of the 2 speed main layshaft.
You can move the 22T layshaft side pulley AWAY from the U6 (6x13x5) bearing in the left bulkhead slightly to avoid binding and rubbing so that the 2 speed spur hub carrier can rotate smoothly and freely with the P13 (3x14 mm) pin.
Earlier somebody posted that you may rub the 24T brake pulley in the middle with the engine crankscase mount. You can slide this 24T brake pulley towards the right bulkhead where the 2 speed gearbox is. However, make sure that the brake pins do not rub on the right rear bulkhead.